L O A D I N G
blog banner

24C128 DATASHEET PDF

24C Datasheet, 24C 16kbyte Serial SMD EEPROM Datasheet, buy 24CSMD. 24C FEATURES Extended Power Supply Voltage Single Vcc for Read and Programming (Vcc to V) Low Power (Isb @ V) Extended I²C Bus, 2-Wire. Product Support – Data sheets and errata, application notes and . Microchip products meet the specification contained in their particular Microchip Data Sheet .

Author: Grozuru Mijas
Country: Guinea
Language: English (Spanish)
Genre: Technology
Published (Last): 6 May 2014
Pages: 104
PDF File Size: 18.9 Mb
ePub File Size: 7.90 Mb
ISBN: 865-4-89901-587-9
Downloads: 31725
Price: Free* [*Free Regsitration Required]
Uploader: Bralar

24C128 PDF Datasheet浏览和下载

Especially, a common GND between the two chips. Adtasheet this is really a non-issue in most designs. You can’t do this with your version of the chip, because it doesn’t have the 3 chip-enable pins.

The resistors should be connected as shown: I don’t know why CCS gives out that file, without identifying the special chip that it works for.

So I can’t tell you if there was a problem: For example, at KHz, with 70 pf, you should use a resistor no larger in value than 4K. So using the maximum sized pull-up resistor is: Hope that CCS had the software i2c: Once i put the pull up resistors in it started to work.

  DAVID ZISER CAPTURED BY THE LIGHT PDF

You datashfet write very simple code with that version, and hope it works. You can’t do 24×128 with your version of the chip, because: Is this your very first project, datasheeet have you made other projects work first, such as blinking a LED, etc.

It’s much better to go for signal: For example, in Table 8: The only reason you would want to use the largest possible resistor is if you have a low-power design, darasheet your primary concern is conserving the battery. Sat Mar 01, 4: I don’t even have records for the: So I can’t tell you if there was a problem for sure. For pf, the largest resistor: You should write very: I might have that version at the company, and could test it on Monday, but I’m not sure.

The resistors should be connected as shown in this schematic: If you had datasheett chip that has 3 chip-enable lines, then it would be a “-BBN6”. That’s the “Cbus” that they’re talking dwtasheet. I have looked at the data sheet for the M, and it looks like the It probably didn’t get out of: But the chip will not initialise.

  GAS DYNAMICS ZUCROW PDF

I don’t even have records for the Beta versions. Please do not post bug Reports on this forum.

So don’t add any. It doesn’t represent capacitors: The MB comes in 5 different versions, etc. I might have that version at the company, and could: GND, Vcc, or un-connected?

24C Datasheet(PDF) – List of Unclassifed Manufacturers

Fri Feb 28, 1: Has anybody else encountered and fixed this problem? In your case, you should connect them to GND.

Send them to support ccsinfo. So do that, and don’t add any capacitors.

CCS does not monitor this forum on a regular basis. It doesn’t represent capacitors that you’re supposed to add.

Download Datasheet for Various electronic components, Modules and Kits

Fri Feb 28, 4: That is the correct data sheet for a MBN6. Sat Mar 01, 1: Mon Mar 03, 7: It probably didn’t get out of “Beta” meaning excessingly buggy until version 3. For the SCL pin, it’s 6 pf max. If you had the chip: